---
title: "SP Series Hollow Linear Shaft: Custom Bore, 12–60 mm OD"
date: 2026-11-18
description: "Product OverviewThe SP series is the hollow counterpart of the SF shaft: same GCr15 steel, same case hardness, with a bore through the middle so the shaft can p..."
source: https://www.mslinear.com/linear-shaft/sp-series-hollow-linear-shaft/
---

# SP Series Hollow Linear Shaft: Custom Bore, 12–60 mm OD

## Product Overview

The SP series is the hollow counterpart of the SF shaft: same GCr15 steel, same case hardness, with a bore through the middle so the shaft can pass a rod, a cable, a coolant line or a second shaft. Wall thickness and bore diameter are machined to the customer drawing, which makes the series useful where weight matters as much as stiffness.

Outside diameters run from 12 mm to 60 mm with a matching bore, and the outside is held to h6 or g6. Because the wall is thinner than a solid shaft, the bending behaviour is different: a hollow shaft of the same outside diameter deflects more, and the [selection guide](/linear-shaft-selection/) gives the moment of inertia needed to compare it fairly with a solid shaft.

Typical uses are rotary shafts with a through bore, lens tubes, and axes where a fixed rod runs inside a moving sleeve. Ends can be threaded or flanged, and the bore can be keyed or stepped.

<table class="ms-spec-table"><tr><th>Parameter</th><th>Specification</th></tr><tr><td>Series</td><td>SP hollow linear shaft, metric</td></tr><tr><td>Outside diameter</td><td>12, 13, 16, 20, 25, 30, 35, 40, 50, 60 mm</td></tr><tr><td>Bore</td><td>Custom inner diameter and wall thickness</td></tr><tr><td>Material</td><td>GCr15 bearing steel (SUJ2)</td></tr><tr><td>Hardness</td><td>HRC 60–62 on the outside</td></tr><tr><td>Case depth</td><td>0.6–1.5 mm up to 15 mm OD; 0.8–2.0 mm 16–25 mm; 0.8–3.0 mm above 30 mm</td></tr><tr><td>Tolerance</td><td>h6 or g6 outside, per size table</td></tr><tr><td>Maximum length</td><td>6000 mm; longer by butted joint</td></tr><tr><td>Concentricity</td><td>Bore and outside ground in one set-up</td></tr><tr><td>End machining</td><td>Thread, flange, step, keyway</td></tr><tr><td>Minimum order</td><td>1 piece</td></tr><tr><td>Lead time</td><td>10–15 days, drawing required</td></tr></table>

## Product Features

- Bore and outside diameter are ground in one set-up, so the wall stays even and the shaft does not whip at speed.
- Wall thickness is chosen from the load, not from stock: thin walls save weight, thick walls hold stiffness.
- The through bore can carry a rod, a cable or a coolant line without a second shaft alongside.
- Hardness and case depth follow the same specification as the solid SF series.
- Bore ends can be chamfered, threaded or fitted with a flange for a bearing seat.

## Applications

Where the bore also has to transmit torque, a [ball spline](/ball-spline/linear-ball-spline-rs-type/) does the job with a keyed race instead of a plain bore.

## About MS Linear

MS Linear is a Chinese manufacturer of precision motion components: profile guideways, ball screws, ball splines, linear shafts, cylindrical guides, linear bearings and single-axis modules. Parts are built to drawing, inspected before shipment, and shipped worldwide.
