---
title: "Ball Screw vs Ball Spline: Functions, Differences and How to Choose"
date: 2026-11-20
description: "Ball screws and ball splines both use recirculating balls between a shaft and a nut, but they serve different jobs. Understanding the force each one carries avo..."
source: https://www.mslinear.com/news/ball-screw-vs-ball-spline/
---

# Ball Screw vs Ball Spline: Functions, Differences and How to Choose

Ball screws and ball splines both use recirculating balls between a shaft and a nut, but they serve different jobs. Understanding the force each one carries avoids putting the wrong component in the axis.

## What a ball screw does

- Converts rotary motion into linear motion, or linear motion back into rotary, through the helix angle of the thread.
- Carries axial load along the shaft axis; the nut moves linearly as the screw rotates.
- Used for feed axes, positioning stages, presses and clamps where thrust and positioning are required.

## What a ball spline does

- Transmits torque while allowing the outer member to slide linearly along the spline shaft.
- Carries radial load and torsional rotation load through the ground spline grooves and balls.
- Used where a part must rotate and slide together, such as indexing, pick-and-place, feed spindles and clutch mechanisms.

## Key differences at a glance

- **Motion:** ball screw converts rotary to linear; ball spline transmits torque with free sliding.
- **Load:** ball screw mainly carries axial thrust; ball spline carries radial load plus torque.
- **Lead and rotation:** screw lead sets linear travel per turn; spline groove count and ball diameter set torque capacity.
- **Setup:** screw pairs with a driven motor and support bearings; spline pairs with a rotating or sliding nut housing.

## Which one to choose

- Choose a ball screw when the axis needs controlled linear thrust and positioning over a stroke.
- Choose a ball spline when the application must transmit rotation while sliding along the shaft.
- Some machines combine both: a screw for feed, a spline for rotary sliding on the same spindle.

## Sourced to your requirement

MS Linear supplies [ball screws](/ball-screw/) and [ball splines](/ball-spline/) cut to length, with end machining, matched nuts and coatings on request. Send the drawing or original part number; standard series dispatch in 3–10 days, custom versions run 15–20 days. [Request a review of your axis](/inquiry/).
